In this easy-to-follow manual you can learn how to remove FIBARO device from SmartThings system.
Remember that during the exclusion process your device has to located within the direct range of your controller.
- Open your SmartThings app and find the device you want to remove. Tap it.
- Tap the gear icon to go to the settings.
- Find the Remove button and tap it.
- Confirm the removal.
- Click the button (the number of clicks depends on your device).
- Move and hold your hand close to the center of the pad.
- If the device is battery powered, high pitched beep will signal exiting the Standby Mode.
- Loud sound sequence will confirm entering the menu, keep holding your hand.
- After hearing two short beeps (green indicator colour), withdraw the hand and perform swiping up gesture to confirm selection (two beeps will confirm validity).
- After a successful removal, you will see the confirmation.
Click the Button at least six times.
Quickly, triple click the button located on the casing.
Quickly, three times press switch no. 1(turns the light on) or the B-button (located on device’s casing.
Quickly, three times press one of the TMP buttons (while the other button is pressed).
Quickly, press three times switch no. 1 or the B-button.
Quickly, three times press the TMP button.
Power the device (insert the battery).
Click any button three times.
LED will pulse white during the adding process.
Click any button three times.
LED will pulse white during the adding process.
Quickly, three times press the B-button – LED diode will glow blue to confirm setting into learning mode.
Quickly, press three times switch no. 1 or the B-button.
Quickly, three times press the B-button or switch connected to one of the inputs.
Quickly, three times press the B-button or switch connected to one of the inputs.
Quickly, three times press the B-button.
Quickly, three times press the S1 switch.
Quickly, triple click the B-button.
March 15, 2018 4984 Tutorials
Total 8 Votes:
1
7