For the Home Center to be configured properly, perform Wizard procedure in Home Center Configuration Interface. Following step are mandatory for full configuration:
- Update the gateway to the newest firmware.
- Configure the FIBARO alarm:
- Enable or disable it.
- Set the user PIN.
- Set location of the gateway.
- Set name of the gateway.
- Add at least one room to the gateway.
- Add at least one device to the gateway.
- Connect the gateway to FIBARO ID and Remote Access.
You can also contact one of our certified installers (see https://www.fibaro.com/en/where-to-buy).
For the Home Center to be configured properly, perform Wizard procedure in Home Center Configuration Interface. Following step are mandatory for full configuration:
- Update the gateway to the newest firmware.
- Configure the FIBARO alarm:
- Enable or disable it.
- Set the user PIN.
- Set location of the gateway.
- Set name of the gateway.
- Add at least one room to the gateway.
- Add at least one device to the gateway.
- Connect the gateway to FIBARO ID and Remote Access.
You can also contact one of our certified installers (see https://www.fibaro.com/en/where-to-buy).
For the Home Center to be configured properly, perform Wizard procedure in Home Center Configuration Interface. Following step are mandatory for full configuration:
- Update the gateway to the newest firmware.
- Configure the FIBARO alarm:
- Enable or disable it.
- Set the user PIN.
- Set location of the gateway.
- Set name of the gateway.
- Add at least one room to the gateway.
- Add at least one device to the gateway.
- Connect the gateway to FIBARO ID and Remote Access.
You can also contact one of our certified installers (see https://www.fibaro.com/en/where-to-buy).
For application to work properly, the Home Center gateway must be configured.
For the Home Center to be configured properly, perform Wizard procedure in Home Center Configuration Interface. Following step are mandatory for full configuration:
- Update the gateway to the newest firmware.
- Configure the FIBARO alarm:
- Enable or disable it.
- Set the user PIN.
- Set location of the gateway.
- Set name of the gateway.
- Add at least one room to the gateway.
- Add at least one device to the gateway.
- Connect the gateway to FIBARO ID and Remote Access.
You can also contact one of our certified installers (see https://www.fibaro.com/en/where-to-buy).