The device allows for connecting switch to the S1 and S2 terminals. These may be momentary (recommended) or toggle switches.
Switch buttons are responsible for managing the blind’s movement.
After releasing the switch a spring automatically pushes back and disconnects the switch).
Operates as a two-position switch, it has no spring that would set one position of the switch.
– switch connected to the S1 terminal
– switch connected to the S2 terminal
- Using momentary switches:
Click switch – initiate up movement.
Click switch – initiate down movement.
If the blind is moving, clicking any button, will stop the movement.
- Operating slats of venetian blinds
When operating venetian blinds it is possible to manage angle of the slats.
Hold switch – initiate slats rotation up.
Hold switch – initiate slats rotation down.
- Using toggle switches:
Change switch state – initiate up movement.
Change switch state – initiate down movement.
Choosing a middle position stops the blinds.