The DHT22 sensor may easily be installed wherever humidity and temperature measurements are required.

You can connect only 1 DHT22 sensor to TP-TD terminals.

  1. Disconnect power.
  2. Connect with the diagram below:

    Diagram 4: Example connection with DHT22 sensor (1 – DHT22 sensor).
  3. Verify correctness of connection.
  4. Power the device.
  5. Add the device to the Z-Wave network.
  6. Change values of parameters:
    • Connected to IN1: change parameter 20 to 4
    • Connected to IN2: change parameter 21 to 4