1. Turn off the alarm system.
  2. Connect with one of the diagrams below:

    Diagram 1: Example connection with regular alarm line (1 – alarm sensor, 2 – alarm system hub).

    Diagram 2: Example connection with parametric alarm line (1 – alarm sensor, 2 – alarm system hub).
  3. Verify correctness of connection.
  4. Arrange the device and its antenna in the housing.
  5. Power the device.
  6. Add the device to the Z-Wave network.
  7. Change values of parameters:
    • Connected to IN1:
      • Normally close: change parameter 20 to 0
      • Normally open: change parameter 20 to 1
    • Connected to IN2:
      • Normally close: change parameter 21 to 0
      • Normally open: change parameter 21 to 1