Reset procedure erases memory of the device, including all information on the Z-Wave network and the main controller.
Resetting the device is not the recommended way of removing the device from the Z-Wave network. Use reset procedure only if the primary controller is missing or inoperable. Certain device removal can be achieved by the procedure of removing.
Resetting the device:
- Disconnect the power supply.
- Press and hold the B-button.
- Connect the power supply while holding the B-button.
- Wait around 10 seconds.
- Release the B-button.
- Disconnect the power supply.
- Connect the power supply again.
- After few seconds the device will be reset.