Connecting the FIBARO Dimmer 2 in a manner inconsistent with manual may cause risk to health, life or material damage.

When connecting FIBARO Dimmer 2 act in accordance with the following rules:

  • Connect only in accordance with one of the diagrams
  • Dimmer 2 should be installed in a wall switch box compliant with a relevant national safety standards and with depth no less than 60mm
  • Electrical switches used in installation should be compliant with the relevant safety standards
  • Length of wires used to connect the control switch should not exceed 20m

 

Notes for the diagrams:

  L – terminal smart light dimmerfor live lead
  S1 – terminal for switch no. 1 (has the option of entering the device in learning mode)
  S2 – terminal for switch no. 2
  Sx – power output terminal for connected switch(es)
  N – terminal for neutral lead
smart light dimmer – output terminal of the Dimmer 2 (controlling connected light source)
  B – service button (used to add/remove the device and navigate the menu)

 

Installation of the FIBARO Dimmer 2:

  1. Switch off the mains voltage (disable the fuse)
  2. Open the wall switch box
  3. Connect with one of the diagrams below.
  4. After verifying correctness of connection switch on the mains voltage
  5. Wait around 30s for the calibration process to end, light may blink during the process
  6. After successful calibration the device will be turned off by default
  7. Add the device to the Z-Wave network
  8. Turn off the mains voltage, then arrange the device and its antenna in a wall switch box
  9. Close the wall switch box and turn on the mains voltage

After switching on the mains voltage LED indicator will signal Z-Wave network inclusion state with a colour:

  • GREEN - device added
  • RED - device not added
  • RED/GREEN ALTERNATELY - Z-Wave error

Switch connected to the S1 terminal is a master switch. It activates the basic functionality of the Dimmer 2 (turning the light on/off, dimming) and starts the learning mode (Add/Remove). The switch connected to the S2 terminal is an optional switch and pushing it without changing the configuration parameters will not affect the status of the device. Functionality of the switches can be reversed by adjusting advanced parameter

 

smart light dimmer

 

 

 

 

 

 

 

 

 

 

 

 

 

smart light dimmer

 

 

 

 

 

 

 

 

 

 

 

 

 

smart light dimmer

 

 

 

 

 

 

 

 

 

 

 

 

 

smart light dimmer
 

 

 

 

 

 

 

 

 

It is not recommended to install different types of wall switches (momentary, toggle, etc.) in a 3-way connection.

 

 

smart light dimmer